Kinetek AC Controllers are designed for low voltage electric vehicle applications using a three-phase, AC induction traction motor. Kinetek controllers use a Digital Signal Processor to run state-of-the-art algorithms with field oriented control and space vector pulse width modulation to optimize efficiency and battery life.

Four controller models provide control across a wide range of battery voltages; the KCCA0007 for 24V vehicles; the KCCA0020 for 36V vehicles; the KCCA0021 for 48V vehicles; and the KCCA0033 for 72V vehicles. Each controller provides fully solid state, four-quadrant, bi-directional operation with regenerative braking.

Features:
	24, 36, 48, and 72VDC models
	Up to 8 vehicle inputs at battery B+ voltage
	6 active high inputs for switches to B+
	Enable / seat switch options
	Forward & Reverse directional inputs
	3 spare inputs
	2 active low inputs for switches to B-
	Quadrature encoder (Digital speed sensor inputs)
	Up to 6 vehicle outputs at battery voltage
	2A rating
	Open drain (Sink to B-)
	Over current / short circuit protection
	Line contactor driver
	Spare outputs
	PWM capable
	Up to 6 analog inputs
	POT1: 2-wire or 3-wire (throttle), 5 to 10k Ohm
	POT2: 2-wire, 5 to 10 k Ohm
	2 channel analog speed sensor inputs (resolver type)
	Motor temperature input (thermistor / RTD)
	Spare analog input
	Key switch input (Logic power from B+)
	Pre-charge circuit
	Serial communication
	RS-232 (for user confi guration)
	CAN 2.0b
	FLASH in-circuit reprogrammable memory
	EEPROM user programmable confi guration memory
	Fault Checks and Indicator (Fault codes also available via serial communication)
	LED 1, LED 2: Fault Code (Red)
	LED 3: Power On (green)
	LED 4: Motor Enabled (green)

Related Products:
	DC Wound Field Motors			Low Voltage AC Motors
	Permanent Magnet DC Motors			Hydraulic Pump Motor Systems
	Transaxle Drive Systems			Single Wheel Drives
	High Frequency Battery Chargers