Kinetek Mark I High Frequency Battery Chargers operate from 100 to 140V AC, 60 Hz power. Chargers are available in the four models/capacities listed above. Sophisticated control circuitry ensures an optimum charging sequence, varying the charging rate to provide a finished charge without stressing battery elements. All Mark I chargers are fully automatic and provide a three-stage charging sequence:

• Main Charge - Maximum current to the battery to a preset voltage level.
• Finish Charge - Regulated voltage level to the battery to a preset current level.
• Equalization Charge - Regulated finish current level until reaching the preset equalizing voltage level at which point the charger enters Adaptive Equalization Mode, regulating output at equalization voltage for a period of time directly proportional to the depth of discharge until charge cycle termination.

This microprocessor controlled charging sequence matches the charging algorithm preferred by battery manufacturers. The high frequency Kinetek design allows the physical size and weight of the charger to be minimized along with heat generation - all models cool through natural convection and require no noisy, failure-prone, cooling fans.

Mark I chargers are compatible with AGM, GEL and Flooded electrolyte battery systems.

Features:
	Automatic three-stage charging sequence
	Automatic current and voltage limits
	Automatic battery disconnect and short
	circuit detection
	Temperature compensation
	Low ripple voltage (0.1V RMS at full load)
	Durable, continuous, maximum output use
	Programmed charge soft start
	Automatic restart if charging battery is
	swapped out
	Terminates charge if charge rate falls
	below a preset value
	Reverse polarity protection
	Standard or customer-supplied charging
	terminations
	Simple, high visibility LED diagnostics
	Compact size; light weight; quiet operation
	Natural convection cooling
	Optimized charging sequence provides
	finished charge and maximizes battery life
	Easily accessible, front panel mounted,
	slow blow fuse, circuit protection
	Drip tight, steel enclosure

Related Products:
	DC Wound Field Motors			Low Voltage AC Motors
	Permanent Magnet DC Motors			Hydraulic Pump Motor Systems
	Transaxle Drive Systems			Single Wheel Drives
	High Frequency Battery Chargers